Chemglass CG-15009-01 - Manual (Page 4)

4
Setup & Operation:
1. Connect the heater / heating mantle to the load receptacle (located on the rear of the unit).
2. Plug the power cord of the Power Controller into an electrical outlet (Rated 120VAC).
3. Turn the ON/OFF switch to its ON position. In the ON position, the switch will be illuminated.
4. Now you’re ready to control your heater / heating mantle load. Turn the control knob to your desired power setting.
5. The heating mantle will now heat up.
6. When the knob is pointed at 100%, full power will be applied to the load. (Refer to Table 1)