ConTech Lighting CGL12 - Manual (Page 2)

For Con-Tech Lighting 12" LED Decorative Pendant Series: CGL12
CGL12 INST www.contechlighting.com All specifications subject to change without notice. 1-847-559-5500 This document can be recycled. 2
4
CANOPY INSTALLATION:
Prior to installation, ensure a 4" Round or Square (with a Round-to-
Square Junction Box Cover Plate) Junction Box is properly
mounted to the ceiling structure
Loosen the two (2) side screws on the canopy (Figure 4), unhook
safety chain and remove mounting bracket from the canopy.
Attach the mounting bracket to junction box.
Position canopy and pendant assembly close to mounting bracket
and reconnect safety chain.
ELECTRICAL CONNECTION:
Connect the primary leads from the junction box to the primary
leads of the fixture (Black-to-Black, White-to-White and Green-to-
Ground). (Figure 4)
Carefully tuck excess wires and connectors in Junction Box while
positioning the canopy in place. Twist and lock canopy and tighten
side screws to complete assembly.
IMPORTANT SAFETY INSTRUCTIONS:
• Read all the instructions before installation. Save instructions for
later use.
• Turn off power at fuse or circuit breaker box before installation
of before doing any maintenance work.
• Wear rubber soled shoes and work should be done on a sturdy
wooden or non-conductive ladder.
• Product must be mounted in locations and at heights in a manner
consistent with its intended use, and in compliance with National
Electrical Code and local building codes. For indoor use only.
• Product must be grounded to avoid potential electric shock and
any other potential hazards.
• Do not exceed the nominal supply voltage or amperage ratings.
• Make sure all screws are properly tightened.
• Do not install any lamp holder closer than 6" from any curtain or
similar combustible material.
• Use only fixtures and fittings intended for use with Con-Tech
Decorative Stemlight Pendant systems.
• Installing contrary to instructions may cause unsafe conditions.
• Warning: Risk of fire. Most dwellings built before 1985 have supply
wire rated at 60˚C. Consult a qualified electrician before installation.
• Warning: Risk of burns. Lamps are extremely hot when lit. Allow
lamps to cool down in temperature before handling.
• To avoid hazards to children, account for all parts and properly
dispose of all packing materials.
• Call the Technical Support department at Con-Tech Lighting with
any installation questions: 847-559-5500.
White
to
White
Black to Black
Green to Green
(Ground Wire)
Black
Green
Green
White
White
Black
Black
Green
Green
Red
18-3 Cable
Strain Relief
Bracket
Junction Box
Ceiling
Mounting Bar
Driver
Canopy
(2) Side Screws