EZ Dupe 5 Copy 3.5" SATA Hard drive Duplicator copies up to 60MB/s. Adapter is needed for 2.5 SATA HDD" - Manual (Page 15)

SATA HDD Duplicate Controller Manual
3.10.3 Compare Firmware
This function is used to compare the current system firmware version with the new version the user
is upgrading to. This ensures that the downloaded firmware is the latest version. The message
"Last update F/W" indicates that it is the latest version.
8-04.Adv Setup
Compare Firmware Searching F/W ...
Please Wait ... Last update F/W
OK!
3.10.4 Quick Erase HDD
This function is used to quickly erase all data on the HDD. Please backup any important data
before using this function.
9-04.Adv Setup
Quick Erase HDD
Press ENT to enter the following screen. Use the Up and Down buttons to select the HDD to
erase.
Quick Erase HDD
ALL/Target CH:*
Press ENT again and the LCD will prompt you to confirm the erase operation.
All data will be
lost,Erase? No
Attention: This is Function 9.5 of 1-1 HDD duplicator.
3.10.5 Full Erase HDD
This function is used to full erase all data on the HDD. Please backup any important data before
using this function.
9-05.Adv Setup
Full Erase HDD
Press ENT to enter the following screen. Use the Up and Down buttons to select the HDD to
erase.
Quick Erase HDD
ALL/Target CH:*
Press ENT again and the LCD will prompt you to confirm the erase operation.
All data will be
lost,Erase? No
Attention: The operation may take a long time, and 1-1 HDD duplicator does not have this function.
14