APC Command Line Interface - Manual (Page 35)

Command Reference: General Management
Command Line Interface (CLI) User’s Guide 31
uploadini
Syntax:
uploadini
Description: Upload an INI file, using
XMODEM, when you are accessing the CLI
through a serial connection. After the upload
completes:
• If there are any system or network changes, the
user interface of the Switched Rack PDU
restarts, and you must log into the CLI again.
• If you selected a baud rate for the file transfer
that is not the same as the default baud rate for
the Switched Rack PDU, you must reset the
baud rate to the default to reestablish
communication with the PDU.
Access: Administrator and device manager
(device-only user).
Parameters: None.
Output Format:
In the following output format, user input is in
bold, and additional instructions, which are not
displayed on the screen, are in italic.
OK
-------------------------------------------------------------
Perform file transfer via XMODEM-CRC?
Enter 'YES' to continue or <ENTER> to cancel:
YES
------- File Transfer Baud Rate-----------------------
1- 2400
2- 9600
3- 19200
4- 38400
>
2
Change baud rate to 9600 and press <ENTER>...
Press E NTER
now.
In the terminal program (such as HyperTerminal)
browse to and select the .ini file to transfer and, if
requested, select XMODEM as the transfer
protocol. The following output is displayed:
Start XMODEM-CRC Transfer Now!
CCC
-------------------------------------------------------------
1536 bytes have successfully been transmitted.
If you selected a baud rate other than the default
9600 for the transfer, reset the baud rate to the
default after the transfer.
Error Message: E101