APC Command Line Interface - Manual (Page 6)

2 Command Line Interface (CLI) User’s Guide
System Requirements
Firmware version required
To use the Command Line Interface, your
Switched Rack PDU must be running firmware
version 2.7.0 for the AOS firmware module and
2.7.3 for the application firmware module.
Rack PDUs required
You can use the command line interface only with
APC Switched Rack PDUs.
Exporting an .ini File
You can configure all parameters of a Switched
Rack PDU (including those for which there are not
specific CLI commands) by using the CLI to
transfer an .ini file to that PDU. The CLI uses
XMODEM to perform the transfer. However, you
cannot read the current .ini file through
XMODEM.
See “uploadini” on page 31.