HES 660 - Manual (Page 2)

2
Installation Directions
Prepare Lock
CAUTION! Before connecting any device at the installation site, verify input voltage using a multimeter.
Many power supplies and low voltage transformers operate at higher levels than listed. Any input voltage exceeding
10% of the solenoid rating may cause severe damage to the unit and will void the warranty.
Prepare Cabinet/Drawer
Finish Installing
DIAGRAM 1: MOUNTING BRACKET INSTALLATION DIAGRAM 2: #8-32 X 5/8” SCREW INSTALLATION
#8-32 X 5/8” SCREW
6. If lock body adjustment is needed to ensure a smooth
capture and release of the hook bracket assembly, loosen
the #10 X 1/2” and #6-32 X 3/16“ screws to adjust the
Multi-Purpose Lock Body until desired clearance is reached.
7. If additional stability is desired, drill two 1/16” pilot holes
and use two remaining #10 X 1/2” screws for final lockdown
of the Multi-Purpose Lock Body as illustrated in Diagram 6,
on Page 4.
8. If the optional key override is used, prepare the
cabinet/drawer as illustrated in Diagram 7, on Page 4.
WARNING: The Multi-Purpose Lock Body must
be wired to a power source prior to insertion of the
Hook Bracket Assembly. Failure to do so may result
in a permanently locked cabinet/drawer.
1. Attach both Lock Mounting Brackets to the
Multi-Purpose Lock Body using four #6-32 x 3/16”
screws as illustrated in Diagram 1.
2. To prevent accidental capture of the Hook
Bracket Assembly prior to the Multi-Purpose Lock
Body being wired, gently thread the #8-32 X 5/8”
screw into the #8-32 threaded hole depicted in
Diagram 2. The #8-32 X 5/8“ screw must only be
tightened snug by hand.
When installed the #8-32 X 5/8” screw will prevent
the capture of the Hook Bracket Assembly by the
Multi-Purpose Lock Body. When wiring is complete,
remove the #8-32 X 5/8” screw. The Multi-Purpose
Lock Body will now be able to capture and
electrically release the Hook Bracket Assembly.
4. Refer to Diagram 4 on page 3 to connect power to the
Multi-Purpose Lock Body. If your Multi-Purpose Lock is
equipped with the RJ-45 option, a diagram for pin
assignments is also provided on page 3, Diagram 4.
If applicable, the LBSM should also be electrically
connected at this time. Remove the #8-32 X 5/8” screw
installed in step 2. Verify catch and release of the
unmounted Hook Bracket Assembly after power is
connected.
5. Mark mounting holes for the Hook Bracket Assembly as
illustrated on page 4, Diagram 5. Drill two 1/16” X 1/2”
deep pilot holes for the Hook Bracket Assembly, and mount
the Hook Bracket Assembly using two #10 X 1/2” screws.
3. Drill four 1/16” diameter pilot holes in the cabinet
using the Mounting Template on page 3, and mount
the Multi-Purpose Lock Body to the inside of the
cabinet/drawer using four #10 X 1/2” screws.
*SHOWN IN LH CONFIG