Kramer Electronics VP-441 - Manual (Page 17)

VP-441 - Controlling the VP-441 13
13
Mode Function
Output resolution: Appears as: Output resolution: Appears as:
1400x1050 SXGA+ [email protected] Hz 480P59
1366x768 WXGA [email protected] 720P59
NATIVE [email protected] 1080I59
640x480 VGA [email protected] 1080P59
NATIVE - Select NATIVE to select the output resolution from the EDID of the
connected HDMI monitor
AUDIO Adjust audio parameters (see Section 6.2.3 )
OSD Set the OSD parameters: H POSITION, V POSITION, TIMER,
BACKGROUND and DISPLAY (see
Section 6.2.4 )
HDCP ON
INPUT Set to ON or OFF.
HDCP support can be enabled (ON) or disabled (OFF) for each of the
HDMI inputs, allowing the source to transmit a non-HDCP signal if required
HDCP ON
OUTPUT Select Follow Input or Follow Output to define whether the HDCP will follow
the input or the output
When Follow Input is selected, the scaler changes its HDCP output setting
(for the HDMI output) according to the HDCP of the input.
This option is recommended when the HDMI scaler output is connected to a
splitter/switcher
When Follow Output is selected, the scaler matches its HDCP output to the
HDCP setting of the HDMI acceptor to which it is connected.
FACTORY
RESET Resets to the default parameters
If you cannot see the display after factory reset, use the front panel Res. button to
set the correct resolution: press continuously for 2 seconds to reset to XGA, or
continuously for 5 seconds to reset to 720p
INFORMATION Displays the source, the input resolution, the output resolution and the
software version and the H/W version
AUTO SYNC
OFF Turn the auto sync ON/OFF. When ON, a short period after not detecting a
valid video signal on the selected input, the unit will disable the H and V
syncs on the analog outputs until a valid input is again detected
EXIT Select to exit the menu