Kramer Electronics VP-690 - Manual (Page 16)

12 VP-690 - Controlling the VP-690
6.2.1 The MAIN MENU
Mode Function
CONTRAST Set the contrast
The range and default values vary according to the input signal
BRIGHTNESS Set the brightness
The range and default values vary according to the input signal
FINETUNE (see Section 6.2.2 )
COLOR Set the red, green and blue shades
SIZE Select the size of the display: FULL, OVERSCAN, UNDER1, UNDER2,
LETTER BOX, PANSCAN (default, FULL)
UNDER1 refers to an underscan of 6% and UNDER2 refers to an underscan of
9%
SOURCE Select the source (default VGA):
Source input Appears as: Source input Appears as:
CV 1 CVBS1 VGA 2 PC 2
CV 2 CVBS2 HDMI 1 HDMI 1
COMP 1 YPBPR 1 HDMI 2 HDMI 2
COMP 2 YPBPR 2 SDI SDI
VGA 1 PC 1
OUTPUT Select the output resolution from the menu (default NATIVE):
Output resolution: Appears as: Output resolution: Appears as:
NATIVE 1080p @50Hz 1080P50
640x480 VGA 1366x768 WXGA
800x600 SVGA 1680x1050 WSXGA
1024x768 XGA 1920x1200 WUXGA
1280x1024 SXGA 1280x800 1280x800
1600x1200 UXGA 1440x900 WXGA+
480i 480I 1400x1050 SXGA+
480p 480P 1600x900 1600x900
720p @50Hz 720P60 2048x1080@50 2K50
1080i @60Hz 1080I60 2048x1080@60 2K60
1080p @60Hz 1080P60 [email protected] 480I59
576i 576I [email protected] Hz 480P59
576p 576P [email protected] 720P59
720p @50Hz 720P50 [email protected] 1080I59
1080i @50Hz 1080I50 [email protected] 1080P59
Select “NATIVE” to select the output resolution from the EDID of the connected
HDMI monitor
AUDIO See Section 6.2.3
OSD Set the OSD parameters: H POSITION, V POSITION, TIMER,
BACKGROUND and DISPLAY (see
Section 6.2.4 )
HDCP ON INPUT Set to ON or OFF.
HDCP support can be enabled (ON) or disabled (OFF) for each of the
HDMI inputs, allowing the source to transmit a non-HDCP signal if
required