Kramer Electronics VP-747 - Manual (Page 33)

28 VP-747 - Operating the VP-747
8.1.1 Preview and Program Setting Commands
Figure 12: Preview and Program Setting OSD Menus
Preview and Program Setting OSD Menus
Setting
Function Default
Input Sub-menu
Source Select the input source: Channel 1 to 8 Channel 1
Type Set the video type: RGBHV, RGBS (PC/Video), RGsB (PC/Video),
YCbCr, Y/C or video, HDMI (for input 1 and input 2 only)
RGBHV
Video Standard Set the Video standard: Auto, NTSC, PAL, PAL-M, PAL-N, NTSC
4.43, SECAM or PAL 6
Auto
H-Position Set the horizontal position for UXGA and component video inputs
The range changes according to the input mode
V-Position Set the vertical position
Frequency Adjust the frequency for UXGA inputs
Phase Adjust the phase only for a VGA Source: 0 to 31 0
Auto Image Assesses the image and improves the quality accordingly, by
automatically adjusting the phase, frequency and position. Upon
completion, the relevant OSD values are updated (H-Position, V-Position,
Phase and Frequency)
Overscan Allows stretching of the outputted picture: On or Off
Enabled only for HD input resolutions
On
Picture Sub-menu
Brightness Adjust the brightness: -50 to 50 0
Contrast Adjust the contrast: -50 to 50 0
Color Adjust the color: -50 to 50 0
Hue Adjust the hue: -180 to 180 0
Sharpness Adjust the sharpness: -50 to 50 0
Output Gamma Adjust the gamma: 1 to 4 1
Film Mode Set the film mode: Auto, Video or Film Auto
Temporal NR Set the temporal noise reduction level: Off, Low, Medium or High
You do not have to press ENTER after selecting the desired
parameter to change it
High
Mosquito NR Set the Mosquito noise reduction level: Off, Low, Medium, High Low
Block NR Set the block noise reduction level: Off or On High
Detail
Enhancement
Set the detail enhancement: Off, Low, Medium or High Off