Kramer Electronics TP-107AVR - Manual (Page 19)

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Configuring a TP-107AVR System
16
5.3 Configuring the TP-107AVR/TP-122 Kit with the RC-108
1
To configure a presentation system as illustrated in the example in Figure 11 ,
do the following:
1. Connect the computer graphics source on each TP-107AVR machine
in the chain (see Section 5.1
2. Interconnect the TP-107AVR machines via the CAT 5 and K-NET
cables.
).
3. Connect the RC-108 Presentation Controller to the chain via the K-
NET port 2
4. Connect the last TP-107AVR unit to a receiver (for example, the
Kramer TP-122
.
3
5. Set the RS-485 TERM switch on the first and the last unit to ON.
), which is connected to an acceptor (for example, a
projector and an AV receiver with speakers).
6. Set an address number for each TP-107AVR unit via the two rotary
switches (see Section 5.6 ).
Figure 11: Configuring the TP-107AVR/TP-122/RC-108 System
1 From this section on, the RC-108 applies also to the RC-116, unless stated otherwise
2 RS-485 on RC-108
3 Refer to the separate user manual, which can be downloaded at
http://www.kramerelectronics.com