Kramer Electronics RC-8RKL - Manual (Page 16)

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Flash Memory Upgrade
14
Figure 11: The KFR-Programmer Window
2. Select the required COM Port 1 .
3. Click the File button to select the .s19 firmware file included in the package.
4. Click the Send button to download the file. The Send button lights red.
5. Wait until downloading is completed and the red Send button turns off.
6. Disconnect the power on the
RC-8RK.
7. Set the PROGRAM switch to OFF.
8. Connect the power on the
RC-8RK.
6.4 Installing the Web Applet
2
Follow these steps to install the Web Applet:
1. Connect RC-8RK to your PC through computer networking.
2. Start RC Configuration Software and connect to the RC device (see the
RC Configuration and Installation Guide 3 ).
3. In the Device menu select Upgrade Applet option and browse to MC.dat
file included in the package
4. Wait until uploading is completed and the success message appears.
Click OK.
1 To which the RC device is connected on your PC
2 This section is applicable only to firmware version 26.0 and higher and requires RC Configuration Software version
1.26.0.38 and higher
3 On our Web site at http://www.kramerelectronics.com