Kramer Electronics FC-4001 - Manual (Page 4)

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Your FC-4001 Format Converter / TBC
2
Has a looped input for synchronizing to an external source
Has a highly stable internal generator for independent (non-genlocked)
applications
Outputs two SDI signals, the Sync signal, and either: Component video
(Y, B-Y, and R-Y; or RGBS), or when Component video is not selected, both
Composite video and s-Video simultaneously, which is selected on dipswitches
Lets you determine the output video standard (PAL B, PAL M, PAL N,
NTSC 3.58, NTSC 4.43, and SECAM) via the dipswitches
Note, however, that the FC-4001 does not convert between video standards.
In addition, the FC-4001 features:
Front panel buttons for input selection (CV, Y/C, YUV, RGB/S, and
SDI), Genlock, freeze and panel lock
Coarse trimmers and fine trimmers for adjusting the sync phase, and the
horizontal-to-subcarrier phase (SCH)
Control via the front panel buttons; and remotely, by RS-232 serial
commands transmitted by a touch screen system, PC, or other serial controller
To achieve the best performance:
Connect only good quality connection cables, thus avoiding interference,
deterioration in signal quality due to poor matching, and elevated noise levels
(often associated with low quality cables)
Avoid interference from neighboring electrical appliances that may
adversely influence signal quality and position your Kramer FC-4001 away
from moisture, excessive sunlight and dust
4 Your FC-4001 Format Converter / TBC
Figure 1, Table 1, and Table 2 define the FC-4001 Format Converter / TBC.