Memory, Table charging station connector locations – AMX MVP-5100 User Manual

Page 13

Advertising
background image

Introduction

5

MVP-5100/5150 Modero Viewpoint Touch Panels

Memory

The MVP-5100 and MVP-5150 come with 128MB of Mobile DDRAM memory and 256 MB NAND
Flash memory. Neither memory may be upgraded.

Table Charging Station Connector Locations

With the unit facing you, the mini-USB port (for programming and downloading firmware using the
AMX-provided adaptor cable) and the DC power port are located on the lower left side of the device
(FIG. 3). The connector for the Table Charging Station (please refer to the Table Charging
Station
section on page 7) is located
on the bottom of the device.

MVP-5100 Specifications (FG5966-08) (Cont.)

External Components (Cont.)

DC power port:

2.5 mm

port to power the panel away from a Charging Station.

Speaker:

• 4 Ohm
• 2 Watts 300Hz cutoff frequency
• NOTE: Speaker is only used for feedback beeps, and will not transmit

standard audio.

IR Emitters:

Transmit IR over 20 feet (6.10 m) from the panel.
• IR emitters on G4 panels share the device address number of the panel.
• Transmits AMX fixed frequencies at 38KHz and 455KHz and 8 user-

programmable frequencies from 20KHz to 1.5MHz

Operating/Storage

Environment

• Operating Temperature: 0° C (32° F) to 40° C (104° F)
• Operating Humidity: 5% - 85% RH
• Storage Temperature: -20° C (-4° F) to 60° C (140° F)
• Storage Humidity: 5% - 85% RH

Included Accessories:

• MVP-5100 Installation Guide (93-5966-01)
• PS3.0 Power Supply (FG423-30)

Other AMX Equipment:

• MVP-TCS-52: Table Charging Station (FG5966-1X)
• MVP-WCS-52: Wall Charging Station (FG5966-1X)
• MVP-BP-51-NK: Replacement MVP-5100 Battery (FG-5966-25)
• MVP-BP-52: Battery Replacement Kit (FG5966-20)
• MVP-STYLUS-52: Stylus, Pack of 3 (FG5966-30-xx)
• CC-USB: USB Programming Cable (FG10-5965)
• MVP-HP USB 1/8" Adapter (FG5966-23)

FIG. 3

MVP-5100/5150 side view with programming port

Front

Mini-USB port

DC power port

Table Charging

Station Connector

The mini-USB port is only used for uploading firmware to the device. It cannot be
used for headphones, speakers, receiving power, or any other function.

Advertising
This manual is related to the following products: