Kramer Electronics TP-42 - Manual (Page 6)

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Your Component – S/PDIF Line Transmitter and Line Receiver
4
distances, of 50m or so, shielded twisted pair (STP) cable is preferred because
it provides protection from interference (degradation is not apparent).
For long range applications, unshielded twisted pair (UTP) cable is preferred.
However, the unshielded twisted pair (UTP) cable should be installed far away from
electric cables, motors and so on, which are prone to create electrical interference.
In general, it is recommended to use shielded twisted pair (STP) skew-free
Kramer cable BC-SXTP for transmitting VGA signals, and shielded twisted
pair (STP) non-skew-free Kramer BC-STP cable for digital signals.
3.3 Recommendations for Achieving the Best Performance
Achieving the best performance means:
Connecting only good quality connection cables, thus avoiding
interference, deterioration in signal quality due to poor matching, and
elevated noise levels (often associated with low quality cables)
Avoiding interference from neighboring electrical appliances that may
adversely influence signal quality and positioning your TP-41 and/or
TP-42 in a location free from moisture and away from excessive sunlight
and dust
Caution – No operator-serviceable parts inside unit.
Warning – Use only the Kramer Electronics input power
wall adapter that is provided with this unit 1 .
Warning – Disconnect power and unplug unit from wall
before installing or removing device or servicing unit.
4 Your Component – S/PDIF Line Transmitter and Line
Receiver
This section describes the:
TP-41 Component – S/PDIF Line Transmitter, see section 4.1
TP-42 Component – S/PDIF Line Receiver, see section 4.2
4.1 Your TP-41 Component – S/PDIF Line Transmitter
For a description of the TP-41:
Topside, see section 4.1.1
Underside, see section 4.1.2
1 For example: model number AD2512C, part number 2535-000251