Washing cycle ended/remove washing – AEG KO-LAVAMAT 70730 User Manual

Page 27

Advertising
background image

Instructions for use

27

Washing Cycle Ended/Remove Washing

After a washing program has ended, END (EINDE, FIN) lights up on the
program sequence display.

If you selected RINSE HOLD (GEEN CENTR., SANS ESSOR.), the indicator
next to the button START/PAUSE (START/PAUZE, MARCHE/PAUSE)
flashes.

0

1. After a rinse hold, it is first necessary to pump off the water:

– Press either the button START/PAUSE (START/PAUZE, MARCHE/

PAUSE) (water is pumped off and the washing is spun according to
the program which has just run; after pressing the button START/
PAUSE (START/PAUZE, MARCHE/PAUSE) again, the spin speed can also
still be changed during spinning),
or

– turn the program selector to PUMP (POMPEN, VINDAGE) and press

the button START/PAUSE (START/PAUZE, MARCHE/PAUSE) (water is
pumped off without spinning)
or

– turn the program selector to SPIN (CENTRIFUG., ESSORAGE) or SHORT

SPIN (KORT CENTRIFUG., ESSOR. DELICAT) and press the button
START/ PAUSE (START/PAUZE, MARCHE/PAUSE) (water is pumped off
and the washing is spun or gently spun).

After the end of this program step, the indicator END (EINDE, FIN)
lights up.

2. Open the filling door.

As soon as the indicator DOOR (DEUR, PORTE) lights up green, the fill-
ing door can be opened.

3. Remove the washing.

4. Turn the program selector to OFF (UIT, ARRET).

5. After washing, pull out the washing detergent drawer slightly so that it

can dry out. Only lean the door against the washing machine so that
the latter can air out.

3

If the display OVER DOSING (OVERDOS., SURDOSAGE)
lights up, too much washing detergent was used in the
washing program just ended. During the next wash, pay
attention to the dosing information of the washing detergent
manufacturer and pay attention to the filling quantity!

Attention! If the washing machine is not used for a long time:
Close the water tap and disconnect the washing machine from the
electricity mains. (The Aqua Control water protection does not function
if the power supply is interrupted).

OVERDOS.

SURDOSAGE

Advertising