AEG KO-LAVAMAT 70730 - Manual (Page 47)

Setting up and connection instructions
47
Compensate for Floor Unevenness
Floor unevenness can be compensated for and the height can be cor-
rected with the four adjustable screw feet. The height can be adjusted
in a range of +10 ... -5 mm.
To adjust the feet use the special spanner supplied for removing the
transport braces.
0 1. Slide the special key firmly onto
the hexagon head of the
threaded foot as far as it will go.
2. Adjust the screw feet so that the
unit is horizontal and stable. The
unit must not wobble over when
loaded.
3. If necessary, check the setting
with a spirit level.
Attention! Never compensate for
minor floor unevenness with
underlays made of wood, card
etc. Always adjust the adjustable
feet.