American Aimers VIIPRO Image Processor Headlight Aimer - Manual (Page 14)

Vision II Pro TM Manual
Page 14 of 28
SECTION TWO
2.1 SET FLOOR SLOPE
Since few shop areas have the same floor slope, the
floor slope of each aiming bay must be individually
measured and entered. A model G2 split image transit
is provided to measure floor slope.
This function allows changing the floor slope for each
bay. To determine the floor slope of the aim bay area,
use the G2 split image transit and target provided.
Place the transit at the front wheel (either side) of the
vehicle (A) and place the target at the rear wheel (B) of
the same side. Looking through the viewing window on the top of the transit (C) turn the small
thumb screw knob (D) until the black lines on the target are in a straight line. Turn the level
indicator dial (E), on side of transit, until the bubble is centered (F). Floor slope reading is
indicated by level/indicator dial (E). A plus (+) reading indicates vehicle is nose high. Enter the
value measured by using the “Plus” button (Button 2) for a plus reading, or “Minus” button
(Button 3) for a minus (-) reading. Reading on level indicator dial should be rounded up to the
nearest (0.1) of degree. (See instruction sheet with transit for additional details). Press and hold
the appropriate button (Button 2 or Button 3) until the proper value is shown at the bottom of the
screen. When the proper value is displayed, press the “NEXT BAY” button, (Button 4), to enter
the floor slope values for other aiming bays, repeat the previous procedure for each bay. Press
the “FINISH” (Button 5) to exit bay setup and save new values.