American Aimers VIIPRO Image Processor Headlight Aimer - Manual (Page 17)

Vision II Pro TM Manual
Page 17 of 28
SECTION THREE
3.1 AREA/VEHICLE SETUP
The aiming area floor should be relatively clean and dry with no unusually excessively uneven
areas which could affect the positioning of the vehicle or aimer.
Drive the vehicle to be checked into the aiming area, set the parking brake.
Vehicle preparation should include the following:
Remove ice or mud from under fenders.
See that no tire is noticeably deflated.
Check vehicle springs for sag or broken leaves.
See that there is no unusual load in the vehicle.
Check functioning of “level ride” control, if applicable.
Clean lamp lenses.
Check for bulb burn-out, proper beam-switching, and moisture condensation
inside headlamp assembly. If condensation present, replace lamp assembly.
Stabilize suspension by rocking vehicle sideways.
Although the Vision II Pro TM Aimer can “aim” the headlamps of a vehicle with the motor idling, it
is recommended that the engine be turned off during the aiming process. The vehicle headlamps
must be on. Locate the horizontal and vertical adjustment screws. In most cases the hood will
need to be raised to access the adjustment screws.