American Standard BERWICK 7431.821 - Manual (Page 2)

2
1
VALVE OUTLET SUPPLY CONNECTION
3
RED BAND
BLUE
BAND
Connect Red Banded Hose to Left
Valve and Blue Banded Hose to
Right Valve.
Attach COUPLING NUTS (1) of
SUPPLY HOSES (2) and tighten
making water tight connection.
Important: Loop SUPPLY HOSES (2)
as illustrated so they do not kink.
COLD HOT
VALVE INSTALLATION
M 9 6 8 6 4 0 R E V . 1 . 1
4
MOUNTING
SURFACE
Install LOCKNUT (11) and RUBBER WASHER (12) onto VALVE BODY (13).
From under side of mounting surface, install VALVE BODY (13) through valve
mounting holes. Threads of VALVE BODY (13) should extent at least 5/16
of a inch above mounting surface top. Fig. A. Thread DECK ADAPTER (10)
onto VALVE BODY (13) until snug against internal stop. If necessary, adjust
LOCKNUT (11).
1
8
10
9
12
11
13
10
9
12
11
Place RUBBER RING (9) into DECK ADAPTER (10).
13
13
5/16'' MIN.
Fig. A.
INSTALL HANDLES
1
2
4a 4
5
1 3
LEVER HANDLE CROSS HANDLE
FLAT BLADE SCREWDRIVER
Push ADAPTER (1) on VALVE STEM (2). Tighten
STEM SCREW (3) with a flat blade to secure ADAPTER (1).
(Figure A)
Find correct position of HANDLE ASSEMBLY (4, 4a) by adjusting
male teeth on ADAPTER (1) to female teeth in HANDLE (4, 4a).
Thread HANDLE ASSEMBLY (4, 4a) onto DECK
ADAPTER (5) until snug against mounting surface
.
THREAD ON
TO DECK
ADAPTER
2
2
(Figure A)