Altinex DAV0106-V1A2 - Manual (Page 4)

DISTRIBUTION AMPLIFIERS
3
cause harmful interference to radio
communications. Operation of this equipment in
a residential area is likely to cause harmful
interference in which case the user will be
required to correct the interference at his own
expense.
•
Any changes or modifications to the unit not
expressly approved by Altinex, Inc. could void
the user’s authority to operate the equipment.
ABOUT YOUR DISTRIBUTION AMPLIFIER 2
The DAV0106-V1A2 Distribution Amplifier, a
product of exceptional quality and design, consists
of video and stereo audio amplifiers.
The video amplifier is designed to provide six
buffered and amplified outputs from one input
signal. The input and output signals are isolated to
prevent ground loops. An additional BNC connector
is provided to make the input signal available for
additional connections, or to serve as a loop
output. The input termination is switch selectable to
either be 75 Ohms or unterminated.
The audio amplifier is designed to provide six
buffered and amplified outputs for both left and
right channels. The input and output signals are
isolated to prevent ground loops. The input
termination is switch selectable to either be 600
Ohms or high impedance.
The DAV0106-V1A2 Distribution Amplifier will allow
the connection of video and audio amplifiers
simultaneously.
The DAV0106-V1A2 Distribution Amplifier is a
state-of-the-art product with a bandwidth of
130MHz for video signals, which enables it to
remain transparent to the incoming video signals
passing through it. It also has a bandwidth of 10Hz
to 20kHz for audio signals.
The DAV0106-V1A2 can pass NTSC, PAL or
SECAM type video signals. The DAV0106-V1A2
can drive output signals up to 75 feet or more when
it is used with high-quality coaxial cables.
The DAV0106-V1A2 receives power from a
universal power supply and accepts input from 95
to 240 Volts AC at 50 or 60 Hz.
TECHNICAL SPECIFICATIONS 3
FEATURES/
DESCRIPTION Video Audio
Compatibility NTSC, PAL,
SECAM,
Composite
Video
Stereo or Mono
Audio
No of Inputs 1 1
Input
Connector One BNC
Female
One 3.5 mm
5-pin Terminal
Block
Input Signals
Level
1.7V 10 V p-p max
Impedance 75 Ohms or
unterminated
600 Ohms or
high impedance
Type Differential input
isolated from
GND
Differential input
isolated from
GND
No of Outputs 6, +1 input loop 6
Output
Connector Seven BNC
Female
Six 3.5mm
Terminal Blocks
Output
Signals
Level
3V p-p max 10V p-p
Impedance 75 Ohms Low - drives 600
Ohms
Type Outputs isolated
from GND
Differential input
isolated from
GND
Gain 0d B 0d B
unbalanced, +6d
B balanced
Differential
Gain/Phase less than 0.02%
@ 20 IRE, 0.01°
@ 20 IRE
__
Frequency
Compatibility
Typical
Bandwidth
85 MHz @ -3d B 10 Hz – 20 kHz
Flatness 0.1d B to 30
MHz
__