KWorld M120 - Manual (Page 15)

© 2010 KWorld
14
FOUR
FAQ
Q1: The media player unit does not function and the buttons on it do not
work. What should I do?
Q2: There is no picture on the screen. What to do?
Q3: Why can’t I play my movie file?
Q4: Why can’t I adjust subtitle ?
A: It could be that the unit is loading data from the USB storage device and it may
take a while. However, if you are sure that the unit does not function, please try
to unplug the power adapter and plug it again.
A:Please check the followings:
1.Please check if the power adapter is properly connected.
2.Please make sure if the AV, YPbPr or HDMI cable is connected appropriately.
3.Remove the SD memory card or USB device and then plug in again after the unit
is turned on normally.
4.Switch your “video source” to the appropriate one. Use the Video Standard key
on your remote to do so. The order of the source will be switched as followed --
VGA, PAL, NTSC, 480P, 720P(50HZ), 720P(60HZ), HDMI-720P(50HZ), HDMI-
720P(60HZ), HDMI-1080I(50HZ), HDMI-1080I(60HZ), HDMI-1080P(24HZ) ,
HDMI-1080P(50HZ) and HDMI-1080P(60HZ). Just press it until you see the
image.
A:Please double check the movie formats supported by this media player and then
make sure the media player functions normally. If the movie format you wish to
play is supported by this media player, please try to reboot the unit. If it still does
not work, perhaps this format is not supported by this media player.
A:Please keep in mind that some videos or movies you download from the Internet
come with subtitles, which means once you have downloaded the movie, the
subtitles are there already. In that case, you can not use the subtitle functions of
this media player to make any change for the subtitles of these movies.