KWorld M102 - Manual (Page 9)

M102
9
4. The main screen will appear on your TV once you
have switched to the appropriate video source.
However, it is possible to encounter the
“black screen” like the figure at the right.
Tips to solve this problem:
a.Since the default output mode of the media player is “PAL Composite”, you can
connect with AV cables in order to see the picture on the screen, though be in lower
picture definition with approximately 480i. To do so, plug the yellow one of the AV cable
into the Y (the green) port of the media player and then connect the AV cable to AV
input ports of your TV set. Then, you can change the output mode for better pictures
in “SETTING” and do the change at “TV System”. (please refer to the SETTING --> TV
System section of this manual)
b.Another way to solve this problem is to press the “Video Standard” button on the
media player remote control to switch the video output modes of the media player.
For instance, if you use YPbPr as your output mode, you may see “black and white”
pictures or incorrect colors. A good way to solve it is to enter “SETTINGS” on the main
menu and choose “HD YPbPr” at the “TV System”.
The “Video Standard” button on the media
player remote:
Each time you press this button, the video
output mode is switched in the following order:
” PAL Composite / PAL Interlace / PAL
Progressive / NTSC Composi te / HD YPbPr /
HDMI / NTSC Interlace/NTSC Progressive”.
You will see the picture when you switch to the
video output mode that matches your signal
(YPbPr, HDMI) and TV system.