Agilent Technologies 8510 User Manual
Page 25
25
4. Change the class label for S
11
A: LABEL CLASS,
S
11
A, ERASE TITLE.
5. Enter the label of PSHORT 1 by using the knob,
the SELECT soft key and the SPACE soft key.
6. Complete the label entry procedure: TITLE
DONE, LABEL DONE.
Follow a similar procedure to enter the remaining
standard classes and labels as shown in the table
below:
Finally, change the cal kit label as follows:
1. Press LABEL KIT, ERASE TITLE.
2. Enter the title “P BAND.”
3. Press TITLE DONE, KIT DONE (MODIFIED). The
message “CAL KIT SAVED” should appear.
This completes the entire cal kit modification for
front panel entry. An example of programmed
modification over the GPIB bus through an exter-
nal controller is shown in the Introduction To
Programming section of the Operating and Service
manual (Section III).
Standard
Standard
Class
class numbers
label
S
11
B
2
PSHORT 2
S
11
C
3
PLOAD
S
22
A
1
PSHORT 1
S
22
B
2
PSHORT 2
S
22
C
3
PLOAD
FWD TRANS
4
THRU
FWD MATCH
4
THRU
REV TRANS
4
THRU
REV MATCH
4
THRU
RESPONSE
1,2,4
RESPONSE