Revolabs Executive HD - Manual (Page 17)

- 17 -
Monitor – Microphone Lock:*
Each microphone has individual lock capabilities. By turning on the lock for a specific
microphone, the microphone mute button will deactivate leaving the user without the ability to
individually control the microphones mute status at the microphone. However, the HD Control
Panel Software, as well as any connected Serial Control Processor, will still have the ability to
control and monitor all locked microphones.
Note: A microphone lock is stored in the Base Station. If a new microphone is paired to a locked
channel, that microphone will then be locked as well. The same goes for a locked microphone that is
paired to an unlocked channel, that microphone will then be unlocked.
Monitor – Microphone Mute:*
Each microphone has individual mute capabilities. The HD Control Panel Software provides
the user the ability to mute and unmute a microphone from their PC. These mute controls will
always remain synchronized to the actual state of the microphone. If the microphone state is
changed through another method, the mute controls will display that change.
Monitor – Microphone Gain:*
Each microphone has an individual gain fader. This fader provides +/- 10dB of gain in 5dB
increments. The microphone gains are stored in the Base Station and will be applied to any
microphone paired to that channel.
Monitor - Microphone Status:*
This provides the current status for the microphone paired to each channel. The status can read any
of the following states:
Monitor - Microphone Type:
This provides the current type for the microphone that is paired to each channel.
Monitor - Microphone Version:
This provides the current firmware version for the microphone that is paired to each channel.
Note: The microphone firmware version must match the Base firmware version for the system to
function properly. A mismatch may result in no audio from the microphones.
Monitor - Microphone Battery:
This provides the current battery level for the microphone that is paired to each channel and active.
The value changes in 12.5% increments and represents the bottom of the range the battery is in.
Therefore a value of 87% means that the battery level is between 87%-100%.
Monitor - Pairing:*
This provides the ability to activate pairing mode for the respective base station channel. It also
provides the pairing status of any base station channel already in pairing mode. The pairing controls
will work regardless of the state of the ‘Base Pairing Lock’
OFF = Microphone is has been turned off
ON = Microphone is on and operational
CHRG = Microphone is in the Charging Base
OUT = Microphone is out of range and cannot communicate