Revolabs Executive HD User Manual

Page 35

Advertising
background image

- 35 -

2. Connect the Charger Base to your computer using the Mini-USB cable provided.

Make sure that the charger is plugged in and powered on and that the microphones
are in it.

3. Connect to the Base Station using an Ethernet cable. This can be done via a direct

connection to the PC or through a DHCP router or switch.

4. Set your PC IP address. The PC and Base station must be both set to a fixed IP

address or both connected to a DHCP router and have DHCP turned on. (See Using
the Revolabs HD Control Panel Software)

5. Start the Revolabs HD Control Panel software.
6. Select ‘Scan Network’ from the ‘System’ menu.
7. Select the Base Station you which to update and click ‘OK’
8. Select ‘Update Firmware’ from the ‘Firmware’ menu.
9. Browse to the firmware file on your PC and click ‘OK’
10. Select the Base Station that you would like to update.
11. Choose whether you would like to update the base, mics, or both.
12. Select OK and watch the firmware process either on the Base Station front panel

display or in the ‘monitor’ tab in the Revolabs HD Control Panel program. The HD
Control Panel will notify you when the process is complete.

Note: A Base Station must either be connected to a DHCP server or have a fixed IP address in
order to receive a firmware update. A Base Station that is set to DHCP with no DHCP server
present will fail in any update attempt.

Advertising