Revolabs HD Single & Dual Channel System — Tandberg C20 - Manual (Page 2)

Connecting the Cables
1. Insert the 3.5mm balanced male connector to the CH 1 OUT port on the Single
or Dual Channel System. If using a Single Channel, DIP Switch #1 should be
“OFF”. If using a Dual Channel, DIP Switch #1 should be “ON”.
2. Insert the 3.5mm TRRS male connector into the Tandberg MICROPHONE 1 port
3. Verify that DIP Switch #3 (mic/line) is “ON”
2
T ANDBERG C ODEC C20 A DMINISTRATOR ’ S G UIDE © J ULY 2009
2
+
-