Revolabs HD Single & Dual Channel System — Tandberg Edge 75/85/95 - Manual (Page 2)

Connecting the Cables
1. Connect the 3.5mm stereo male cable to the CH 1 OUT port on the Single or
Dual Channel System. If using a Single Channel, DIP Switch #1 should be
“OFF”. If using a Dual Channel, DIP Switch #1 should be “ON”.
2. Connect the XLR male cable into the Tandberg MIC 1 port
3. Verify that DIP Switch #3 (mic/line) is “ON”
2
2