Revolabs Fusion Setup Guide - Manual (Page 9)

STEP 3: Pairing Microphones to Fusion
Base Station if Necessary
If you selected your microphones separately with the 01-8FUSION(EU)-NM or
01-4FUSION(EU)-NM Fusion part numbers, you must first establish a
connection between your microphones to the Fusion Base Station. This is
called “pairing”.
Pairing creates a link with a unique electronic serial number between the Solo
wireless microphone and the Fusion Base Station. When the microphone and
Base Station have been previously paired, the microphone will automatically try
to connect to the Base Station whenever it is lifted from the Charger Base.
Note: Microphones in new systems must be paired to the Base Station
with each microphone assigned to a unique channel on the base unit.
Remember, microphones are always muted (flashing RED LED light) when they
are removed from the Charger Base and the MUTE button needs to be pressed
to make it “live” (flashing GREEN LED).
A microphone that is not paired will be indicated by either cycling RED-GREEN,
or RED-YELLOW-GREEN LED patterns. A Base Station LED that is not paired
to a microphone will not show any activity on the LED (make sure unit is first
powered on by observing GREEN power LED on the front panel).
When the microphone and Fusion Base Station are paired, both microphone
and channel LEDs will flash RED as microphones are removed from the Charger
Base and flash GREEN when un-muted.
To pair the microphone to the Fusion Base Station:
Turn the microphone OFF (no LED activity). If the microphone is ON, press
and hold the MUTE button for 10 seconds until the LED turns solid RED (do
not release when you hear two beeps). Release the button to turn the unit off.
(Continued on next page.)
Page 9
Revolabs Fusion™