Revolabs Single Channel System - Polycom VSX8000e User Manual
Revolabs Equipment
Revolabs Single Channel System - Polycom VSX8000e Setup Guide
N
OTES AND
C
AUTIONS
:
This setup guide will guide you through the steps needed to properly connect a
Revolabs Single Channel System to a Polycom VSX8000e video codec.
1. Connecting the Cables
2. Configuring the VSX8000e Video Codec
Note:
It is important to carefully follow these instructions in order and completely.
Otherwise your Single Channel System and/or the video codec may not function
properly. Please read through these instructions completely before proceeding.
Contact Revolabs technical support if you have any questions.
Requirements for connecting systems:
1. Revolabs Single Channel System
2. Revolabs 2.5mm to RCA Audio Cable (included with Single Channel)
3. Polycom VSX8000e video codec
*P
OLYCOM
VSX
8000
SERIES VIDEO CODECS HAVE PHOENIX CONNECT ORS FOR LINE INPUT WHILE THE
R
EVOLABS
SINGLE CHANNEL
S
YSTEM USES
RCA
CONNECTORS FOR AUDIO INPUT
/
OUTPUT
.
A
TECHNICIAN COULD SIMPLY CUT
OFF THE ENDS OF THE
2.5
MM TO
RCA
AUDIO CABLE AND CONNECT PER THIS DIAGRAM
(R
EFERENCED FROM THE
P
OLYCOM
I
NTEGRATOR
’
S
R
EFERENCE MANUAL FOR THE
VSX
S
ERIES
V
ERSION
8.7,
A
UGUST
2007):