Revolabs XTAG USB - Manual (Page 8)

-11 -
Revolabs Revolabs Revolabs Revolabs xTag xTag xTag xTag™ ™ ™ ™ Wireless Wireless Wireless Wireless Microphone Microphone Microphone Microphone
The xTag wireless microphone uses encrypted
communication to synchronize with the Charger Base.
The xTag Microphone provides high quality full duplex
audio between the user and the computer.
1. Microphone Port – Receives audio
2. Noise Cancellation Port
3. Mute Button — press to mute, un-mute and pair microphone.
4. Pocket clip — attaches microphone to user or Lanyard.
5. LED display — visual status for mute, un-mute, and pairing.
6. Earpiece jack — accepts the 2.5mm plug for the earpiece.
7. Charging port — charges in xTag charger base.
Using the xTag Microphone
1. Remove the Microphone from the Charger Base.
The double-flashing RED LED on the Microphone
and Charger Base confirm that the mic is paired
and muted.
The Wireless Microphone has a clip on the back
which allows the Microphone to be easily attached
onto a shirt pocket, blouse, lapel or lanyard.
-12 -
2. Attach the Microphone to clothing or to a lanyard
close to the mouth, within 6-12 inches (15–30cm) is
recommended. Make sure microphone is attached
securely with the microphone port pointed up
toward mouth.
3. With the microphone in the wearing position, un-
mute the microphone by pressing and releasing the
Mute button (confirm by viewing flashing GREEN
LED). If the volume is too low, move the
microphone closer to the mouth.
4. To turn the microphone off, return the Microphone
to the Charger Base. The Microphone LED will
show a 5 second self-test pattern and begins
charging (solid RED or GREEN LED). Alternately,
turn off the Microphone manually by pressing and
holding the Mute button for 10 seconds, until the
LED turns solid RED, then release the mute button
and the LED will turn OFF.
If the microphone is moved out of range of the Base
Station (~65 feet or 20m) the connection will be
dropped (LED flashes all colors) and the microphone
will mute.
After 15 seconds the microphone will beep 5 times,
and will continue beeping every 30 seconds to remind
the user to return the microphone to the room. If the
microphone is moved back into range within 15
minutes the connection will automatically be re-
established to its original state, and the beeping will
cease. If not, the microphone will turn off.
Note: The xTag microphone is designed to be used
with the xTag system only. This microphone is not
compatible with other Revolabs Solo™ Executive
systems, nor are Solo microphones compatible with
the xTag Charger Base.