Seiwa Black Box 1000W 50/200kHz - Manual (Page 25)

27 User Manual
3.1.12.1 Shallow Water
Triggers an alarm when depth becomes shallower than the value set.
3.1.12.2 Deep Water
Triggers an alarm when depth becomes deeper than the value set.
3.1.12.3 High Water Temp
Triggers an alarm when the transducer reports a temperature (from TEMP 1 sen-
sor) above the value set.
3.1.12.4 Low Water Temp
Triggers an alarm when the transducer reports a temperature (from TEMP 1 sen-
sor) below the value set.
3.1.12.5 Water Temp Rate
Triggers an alarm when the transducer reports a temperature (from TEMP 1 sen-
sor) variation rate above the value set.
3.1.12.6 Fish Alarm
The options for Fish Alarm set the size of the fishes that, if detected by the unit,
switches an alarm to sound. These options are: Off, Small, Medium, Big and
Huge. The alarm sounds if the set size (or bigger) is detected.
3.1.13 Save & Load
Insert the USER MEDIA into the slot, then follow the procedure:
[MENU] + "Save & Load" + [ENTER]
Fig. 3.1.13 - Fish Finder Save & Load menu
3.1.13.1 Load Settings from User Media
Load the complete settings from the UER MEDIA and changes the active menu
settings.
3.1.13.2 Save Settings to User Media
This is useful to avoid the user havin to retune up Fish Finder after a Clear RAM
operation or a software update.
3.1.13.3 Restore Current Preset Defaults
Restors the default values only for the current presets (see Par. 3.1.1, Preset
Mode) and does not affect the other presets.