Silent Call LLS-04 - Manual (Page 2)

Revision 3
5095 Williams Lake Road, Waterford Michigan 48329
(800) 572-5227 (Voice / TTY)
2. The lamp can be turned on and off manually by pressing the large button on top of the Lamp
Lighter. The Lamp Lighter will indicate alerts whether the lamp is on or off.
3. If for any reason the lamp is unplugged, turned off at the lamp, or burned out, the Lamp
Lighter will periodically flash all LEDs to indicate a problem with the lamp.
4. An optional VIB-PJ bed vibrator and strobe may be connected to the vibrator jack and strobe
jack on the Lamp Lighter power supply and will vibrate the same code as the lamp and the
strobe flashes on earlier models. Remove four screws from the power supply base. Install VIB-
PJ bed vibrator into the vibrator jack insure wires are placed into cable retention cavity of
case for easy routing and proper power supply cover closure (FIQ 2). Install the four screws
securing power supply base.
5. An optional battery backup can be used to supply power to your lamplighter should you loose
house power. Remove the 4 screws and remove power supply base. Install Battery Backup Pack
Plug onto connector (FIQ 2). Install power supply base cover and secure with the four screws
to power supply base.
Fig. 2
Caution
RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE.
DISPOSE OF USED BATTERIES ACCORDING TO INSTRUCTIONS
VIB-PJ Input
Jack
Cable retaining cavity
Battery
Backup
Jack
Strobe Input