Silent Call LLS-04 - Manual (Page 3)

Revision 3
5095 Williams Lake Road, Waterford Michigan 48329
(800) 572-5227 (Voice / TTY)
Programming
1. If you have not changed the position of the switches inside your transmitter(s) from the
factory setting, no further programming is necessary and you can skip this section .
2. Each Silent Call transmitter has a code switch inside the battery compartment.
3. All Silent Call transmitters leave the factory set to a default code of 1=OFF, 2=OFF, 3=OFF,
4=ON, 5=ON. This code can be left at the factory setting unless you are within 300 feet of
another Silent Call system. In that case, erase all learned transmitters (see below) and change
the position of one or more switches on ALL transmitters. All transmitters must be set the
same as the receiver.
4. The Lamp Lighter needs to “learn” the code of the transmitter(s) it is expected to respond to.
It leaves the factory pre-programmed to the same default code as the transmitters.
5. To learn a different code, make sure that the lamp is turned off with the Lamp Lighter button.
Then press and hold the button. After approximately eight seconds the lamp will go out and
the DOOR, WEATHER, FIRE and CO LEDs will illuminate. Release the button. The Lamp
Lighter is in "learn" mode as long as the LEDs are lit and is ready to learn and the code of the
transmitter.
6. While the LEDs are lit, press the button on a transmitter to send a signal. All LEDs will flash in
sequence and then go out, indicating that the Lamp Lighter has received and remembered the
code of the transmitter. Wait five seconds and the Lamp Lighter is ready for use. Test by
pressing the button on any transmitter. Once learned, all codes remain in memory even if power
is removed.
7. The Lamp Lighter only has to be programmed with one transmitter as long as all transmitters
are set to the same code . It will respond to an unlimited number of transmitters on the same
code. The Lamp Lighter can also learn an unlimited number of different codes for large
installations where it is desirable to have some transmitters set to different codes.
Erasing all learned transmitter codes
To erase all codes learned by the Lamp Lighter, disconnect the backup battery if one is installed.
Unplug the Lamp Lighter power supply, press and hold the lamp on/off button and while holding the
button down, plug in the Lamp Lighter power supply. When the LEDs illuminate, release the button.
The Lamp Lighter memory is now cleared. Re-learn any transmitters as desired. Refer to step # 5
to re-program.