Silent Call VC4003-SS - Manual (Page 3)

Charging
You will need to charge your Vibra-Call 3 receiver for 8 hours prior to the first use.
• Pull the arrow tab from battery door.
• Place the Vibra-Call 3 receiver into the Docking port. Note* You must lean the
receiver back on a slight angle to install properly into the Docking Port. If you do not
do this you risk damaging the charging pins.
o If using the Leather Pouch you must remove it before placing the receiver into
the Docking Port.
o If using the optional Rubber Skin you can leave that on the receiver when
placing into the Docking Port.
• The Vibra-Call 3 Receiver will vibrate to let you know that it has been placed into the
Docking port properly.
Programming
(If you are using a smoke detector or fire transmitter with the Vibra-Call 3 you must program
these transmitters first or the supervision will not operate.)
On the rear of the Docking Port is a programming button used to program Signature
Series 418 MHz transmitters to the Vibra-Call 3 receiver. With the Docking Port
power switched on, and the Vibra-Call 3 placed in the Dock:
• Press and hold the program button located at the back of the Docking Port case.
The Vibra-Call will vibrate once, pause for approximately 5 seconds and then
vibrate twice. The unit is now in program mode.
• Release the program button and the unit will remain in program mode for
approximately 30 seconds. While in program mode, the receiver will memorize
the code of the transmitter and then exit program mode.
2