Silent Call VC4003-SS - Manual (Page 4)

3
• While the receiver is in program mode, press the button on any 418 MHz Silent
Call corresponding type transmitter. When the receiver receives the transmitted
signal, it will memorize the code, and exit program mode automatically.
• Remove the Vibra-Call 3 from the Dock, activate the transmitter previously
programmed and the receiver will vibrate as indicated by the Alarm Reference
Chart.
Operation
• When the Vibra-Call 3 receiver is in the Docking port and detects a signal from a
Silent Call 418 MHz transmitter with a matching coding system, it activates the
Docking Port’s bed vibrator and/or strobe light if connected.
• The vibrator or strobe light will continue for approximately 15 seconds after
the transmitted signal ceases except in the case of fire. As long as the Smoke
Detector and/or Fire Alarm Transmitters continue to send an alert signal, the
Vibra-Call 3 receivers alerting circuits will remain on.
• The Vibra-Call 3 has 6 different vibration alert patterns to tell you which type of
transmitted signal was received; Sound, Phone, Door, Weather, CO and Fire.
• During the day, take the Vibra-Call 3 receiver out of the Docking Port and clip it
to your belt using the provided leather pouch or place the unit into your pocket.