AEG L 75280 FLP - Manual (Page 10)

EXTRA RINSE BUTTON 7
Press button 7 to add rinsing phases to
a programme.
Use this function for persons allergic to
detergents and in areas where the water
is soft.
STAIN BUTTON 8
Press button 8 to add the stain phase to
a programme.
Use this function for laundry with hard
stains to remove.
When you set this function, put the stain
remover into compartment
.
This function increases the pro-
gramme duration.
This function is not available with
a temperature lower than 40° C.
SPIN BUTTON 9
Press this button to:
• Decrease the maximum speed of the
spin phase when you set a programme.
The display shows only the spin
speeds available with the set pro-
gramme.
• Deactivate the spin phase.
• Activate the 'Rinse Hold' function. Set
this function to prevent fabric creases.
The appliance does not drain the water
when the programme is completed.
Spin phase is off.
'Rinse Hold' function is
on.
TEMPERATURE BUTTON 10
Press button 10 to change the default
temperature.
- - = cold water
ACOUSTIC SIGNALS
FUNCTION
You can hear the acoustic signals when:
• You activate the appliance.
• You deactivate the appliance.
• You press the buttons.
• The programme is completed.
• The appliance has a malfunction.
To deactivate/activate the acoustic sig-
nals, press button
8 and button 7 at
the same time for 6 seconds.
If you deactivate the acoustic sig-
nals, they continue operate only
when you press the buttons and
when a malfunction occurs.
CHILD LOCK FUNCTION
This function prevents children to play
with the control panel.
• To activate the function, press button
10 and button 9 at the same time un-
til the display shows the symbol .
• To deactivate the function, press but-
ton 10 and button 9 at the same time
until the symbol goes off.
You can activate the function:
• Before you press the Start/Pause but-
ton 4 : the appliance cannot start.
• After you press the Start/Pause button
4 , all the buttons and the programme
knob are deactivated.
PERMANENT EXTRA RINSE
FUNCTION
With this function you can keep the extra
rinse function permanently on when you
set a new programme.
• To activate the function press button
6 and button 5 at the same time un-
til the indicator of button 7 is on.
• To deactivate the function press button
6 and button 5 at the same time un-
til the indicator of button 7 is off.
10 www.aeg.com