Kodak DC210 Plus - Manual (Page 71)

9-5
9
T
roubleshooting
DC200/DC210 Camera
Problem Cause Solution
Ready light does not turn on
and the camera does not work. Batteries are low or
empty. Replace the batteries.
Pictures remain in the
camera’s memory
when the battery is
removed.
Camera is not turned
on. Turn the camera on
and verify that the
green Ready light
turns on.
Shutter button does not work. Camera is not turned
on. Turn the camera on
and verify that the
green Ready light
turns on.
Mode dial is not set to
Capture. Set the Mode dial to
Capture.
Ready light is
blinking. Camera is
processing picture. Wait until Ready light
stops blinking before
attempting to take
another picture.
The Status Display
reads Full. The
memory card is full. Transfer pictures to
your computer or
insert a memory card
that has available
memory.
Camera is connected
to the computer. Disconnect camera
from computer.
Camera does not turn on. Batteries are not
properly installed. Remove the batteries
and install them
according to the
directions on the
outside of the battery
door.
Batteries are weak or
dead. Install new batteries.