Lenovo Secure Managed Client - Manual (Page 14)

Removing and installing the enclosure cover
To remove and install the enclosure cover, do the following:
CAUTION:
The enclosure cover must only be removed by a qualified service person as it
provides access to a service area. Potential hazards include:
v Energy hazard
v Rotating fans
v Hot surfaces
v Access to power supply unit openings
Upon replacements, the cover MUST be secured by tightening the retaining
screw with a screwdriver.
Removing the enclosure cover
To remove the enclosure cover, do the following:
1.
Observe all safety and ESD precautions in the Safety and Warranty Guide.
2.
Release the enclosure cover by using a flat-head screwdriver to turn the lock
mechanism to the unlocked position (see 1 in the following figure). Press in
on the palm latch (see 2 ) and slide the enclosure cover back (see 3 ) until it
stops.
3.
Lift the cover to completely remove it from the chassis.
Figure 1. Unlatching enclosure cover
6 Secure Managed Client (SMC) - Storage Array Hardware Installation and Replacement Guide