Audiovox FPE1508 - Manual (Page 4)

E - 3
QUICK INSTALLATION
TURNING ON THE UNIT FOR THE FIRST TIME
The first time you turn on the unit, the unit will enter the setup mode. You can easily follow the prompt
message on the screen to complete basic TV settings.
1. Press the / button to select Yes. Press the
ENTER
button to proceed with the initial setup.
2. Use the / button to select Antenna, then
press the / button to select Air or CATV.
3. Use the / button to select Auto Scan, then press the button to enter auto scan menu. Use the /
button to select Start to Scan, press the button to begin scanning. (If you selected CATV on Step 2,
you need to select Cable System before Start to Scan). The system will automatically start to scan and
preset all available TV channels.
4. After scanning has finished the system will return to the first TV channel scanned.
Make sure the RF aerial has
been connected properly to the
TV ANTENNA
input jack on the rear
of the system.
When you turn on your television set for the first
time, be sure to place it on a solid stable surface.
To avoid danger, do not expose the TV to water,
or a heat source (e.g. lamp, candle, radiator).
Do not obstruct the ventilation grid at the rear
and be sure to leave sufficient gaps around the
unit as shown.
2 3/8"
2 3/8" 2 3/8"
16159S2_UL_ENGLISH IB.indd 3 1/9/2008 2:13:26 PM