Exiting remote control, Setting up pxe network boot – Lenovo ThinkServer TD200 User Manual
Page 72
1.
Click RDOC.
2.
When the new window opens, click Upload.
3.
Click Browse to select the image file that you want to use.
4.
In the Name field, enter a name for the image and click OK to upload the file.
Note:
To unload the image file from memory, select the name in the RDOC
Setup window and click Delete.
Mapping and unmapping drives with IMM firmware version 1.02
and earlier
To map a drive, select the Mapped check box next to the drive that you want to
map.
Note:
A CD or DVD drive must contain media before it is mapped. If the drive is
empty, you are prompted to insert a CD or DVD into the drive.
If you click Add Image, diskette image files and ISO image files can be added to
the list of available drives. After the diskette or ISO image file is listed in the
Virtual Media Session window, it can be mapped just like the other drives.
To unmap a drive, clear the Mapped check box for the drive. Before the drive is
unmapped, you must confirm that you want the drive to be unmapped.
You can select a diskette image file and save the diskette image in IMM memory.
This enables the disk to remain mounted on the server so that you can access the
disk later, even after the IMM Web interface session has ended. A maximum of one
drive image can be stored on the IMM card. The drive or image contents must be
1.44 MB or smaller. To upload a diskette image file, complete the following steps:
1.
Click RDOC.
2.
When the new window opens, click Upload.
3.
Click Browse to select the image file that you want to use.
4.
In the Name field, enter a name for the image and click OK to upload the file.
Note:
To unload the image file from memory, select the name in the RDOC
Setup window and click Delete.
Exiting Remote Control
Close both the Video Viewer window and the Virtual Media Session window when
you have finished using the Remote Control feature.
Setting up PXE network boot
To set up your server to attempt a Preboot Execution Environment (PXE) network
boot at the next server restart, complete the following steps:
1.
Log in to the IMM. For more information, see Chapter 2, “Opening and using
the IMM Web interface,” on page 9.
2.
In the navigation pane, click PXE Network Boot.
3.
Select the Attempt PXE network boot at next server restart check box.
4.
Click Save.
66
Integrated Management Module: User Guide