ATEN ATEN MasterView KVM CS-62 - Manual (Page 7)

Installation
Refer to the Installation diagram on the next page as you
perform the following steps:
1. Plug your keyboard, monitor, and mouse into the appropriate
Console ports of the CS-62. Each port is labeled with an
appropriate icon to indicate itself.
2. Plug the keyboard, monitor, and mouse connectors of the
attached KVM cables into their respective ports on the
computers you are installing.
3. Turn on the power to the computers.
Note: The CS-62’s Power On default is to link to the first
computer you turn on.
- 5 -
1. Before you begin, make sure that power to all the
devices you will be connecting up have been
turned off. You must unplug the power cords of
any computers that have the Keyboard Power On
function. Otherwise, the switch will receive power
from the computer.
2. To prevent damage to your installation due to
ground potential difference, make sure that all
devices on the installation are properly grounded.
2003-06-20