Caring for your monitor, Detaching the monitor stand, Preparing the monitor for wall-mounting – Lenovo LS2221 Wide 21.5in Flat Panel Monitor User Manual
Page 16
Caring for your monitor
Be sure to turn off the power before you perform any maintenance on the monitor.
Do not:
• Apply water or liquid directly to your monitor.
• Use solvents or abrasives.
• Use flammable cleaning materials to clean your monitor or any other electrical
equipment.
• Touch the screen area of your monitor with sharp or abrasive items. This type of contact
may cause permanent damage to your screen.
• Use any cleaner which contains an anti-static solution or similar additives. This may
harm the coating of the screen area.
Do:
• Lightly dampen a soft cloth with water and use this to gently wipe the covers and the
screen.
• Remove grease or finger marks with a damp cloth and a little mild
Preparing the monitor for wall-mounting
Detaching the monitor stand:
VESA holes
LCD wall-mounting instructions:
1. The gap between the installation holes on the back of
the LCD is 100*100 mm. There should have corresponding
position of holes on the wall-mounting plate.
2. The installation holes on the back of the LCD should be of
regular M4 thread. Select the corresponding screws to use.
3. The effective depth of the threaded holes on the back of
the LCD is 8 mm, the length of the thread of the fixing
screw is recommended as follows: L = 8 mm + installation plate thickness - (1~2) mm.
4. Remove the base and the support. See descriptions on the above illustration.
5. Insert the screw for fixing through the round hole on the wall-mounting plate and screw
it onto the installation hole on the back of the LCD and then tighten it.
6. There are four fixing screws.
Secure the screws
(4 screws)
Wall-mount the
installation plate
© Copyright Lenovo 2011. © Chapter 2. 2-9
Step 1:
Step 3: Remove the Four screws counterclockwise, take off the bracket, and install the
VESA mounting rack.
Step 2: Lift up the cover(as shown), and remove it.