Lenovo LS2221 Wide 21.5in Flat Panel Monitor - Manual (Page 6)

Setting up your monitor
This section provides information on how to set up your monitor.
Connecting and turning on your monitor
Note: Be sure to read the Safety information located on page iii before
carrying out this procedure .
1. Power off your computer and all attached devices, and unplug the computer
power cord.
2. Connect the analog signal cable to the video port on the back of the computer.
Note: One end of the signal cable is already pre-attached to your monitor.
Cable lock slot
Your monitor is equipped with a cable lock slot located on the rear of your monitor (in
the lower position). Please see the instructions that come with the cable lock to learn
how to using it.
Insert the power cord into the monitor, then plug the monitor power cord and the
computer cord into grounded electrical outlets. 3 .
© Copyright Lenovo 2011. © Chapter 1. 1-3