6 installing a dimm – Asus Terminator 2 Barebone System T2-AH1 User Manual

Page 29

Advertising
background image

2 - 9

2 - 9

2 - 9

2 - 9

2 - 9

A S U S T 2 - A H 1

A S U S T 2 - A H 1

A S U S T 2 - A H 1

A S U S T 2 - A H 1

A S U S T 2 - A H 1

2.6

Installing a DIMM

The system motherboard comes with two Double Data Rate (DDR) Dual
Inline Memory Module (DIMM) sockets.

The following figure illustrates the location of the sockets:

Installing DDR DIMMS other than the recommended configurations
may cause memory sizing error or system boot failure. Use any of
the recommended configurations in the table on the next page.

Install only i d e n t i c a l

i d e n t i c a l

i d e n t i c a l

i d e n t i c a l

i d e n t i c a l (the same type and size) DDR DIMM in

DIMM_A1 and DIMM_B1.

If installing only one DDR DIMM, install it in DIMM_A1 (blue slot).

Always install DIMMs with the same CAS latency. For optimum
compatibility, we recommend that you obtain memory modules from
the same vendor.

Due to chipset resource allocation, the system may detect less than
your total system memory size when you enable the onboard VGA.

This motherboard does not support memory modules made up of
128 Mb chips or double-sided x16 memory modules.

2.6.1

2.6.1

2.6.1

2.6.1

2.6.1

Memory configurations

Memory configurations

Memory configurations

Memory configurations

Memory configurations

You may install up to 2 GB system memory using 256 MB, 512 MB, and
1 GB DDR DIMMs.

®

184-pin DDR DIMM sockets

80 Pins

104 Pins

DIMM_B1

DIMM_A1

Advertising
This manual is related to the following products: