ATEN CS-1708 - Manual (Page 34)

CS-1708 / CS-1716 User Manual
26
(Continued from previous page.)
Setting Function
RESET
STATION IDS If you change the position of one of the Stations in the daisy chain,
the OSD settings will no longer correspond to the new situation.
This function directs the OSD to rescan the Station positions of the
entire installation and updates the OSD so that the OSD Station
information corresponds to the new physical layout.
Note: Only the Station Numbers get updated. Except for the Port
Names, all Administrator settings (such as Set Accessible Ports,
Set Quick View Ports, etc.), for all of the computers affected by the
change, have to be manually redone.
SET
OPERATING
SYSTEM Specifies the operating platform of the computer attached to each
port. For each port, press the [Spacebar] to cycle through the
choices (PC, Sun, Mac, and SPC). Repeat until all the ports have
been set, then press [Esc]. The default is PC.
Note: 1. PC stands for PC compatible. This is the choice that
should be made for all operating systems other than Sun
and Mac.
2. If you are installing a Sun or Mac computer, before you
run it for the first time you must set the correct operating
system for the port it is connected to with this function,
otherwise, it will not boot.
3. SPC stands for Special Case. For certain operating
systems (such as FSBD), you may need to choose this
option if you run into startup problems. If this occurs,
please contact technical support for further information.
FIRMWARE
UPGRADE In order to upgrade the CS-1708 / CS-1716’s firmware (See
chapter 5), you must first enable Firmware Upgrade Mode with this
setting.
KEYBOARD
LANGUAGE Sets the keyboard language layout for the computer attached to
each port. Choices are: Auto, English, French, German, and
Japanese. Auto (the default), sets the keyboard language
according to the keyboard language of the computer.
cs1708-1716.book Page 26 Thursday, July 19, 2007 3:06 PM