Single stage installation – ATEN CS-1708 User Manual
Page 18
CS-1708 / CS-1716 User Manual
10
Single Stage Installation
Refer to the installation diagrams on the next page as you perform the
following steps. The numbers in the diagrams correspond to the steps:
1. Plug your USB keyboard, monitor, and USB mouse into the Console Ports
located on the unit's rear panel.
2. Use KVM cable sets to connect any available KVM port to the video and
USB ports of the computers you are connecting up.
Note: 1. Two cable sets are supplied with this package; additional sets
require a separate purchase. See Cables, page 4 for details.
2. The shape of the 15-pin KVM port connectors has been
specifically modified so that only KVM cables designed to work
with this switch can plug in.
3. Plug the power adapter cable into the switch's Power Jack, then plug the
power adapter into an AC power source.
This completes the single stage installation, and you can turn on the power to
the computers.
cs1708-1716.book Page 10 Thursday, July 19, 2007 3:06 PM