Ampro Corporation LITTLE BOARD 5001451A - Manual (Page 77)

Little Board P6d Module
2-59
Setup 7 — Integrated Peripherals Setup
The peripheral interfaces integrated on the Little Board P6d system can be configured on Setup 7
— Integrated Peripherals Setup (Figure 2-13). You can configure the IDE port, USB port, floppy
controller, IrDA port, serial ports, and parallel port from this screen.
INTEGRATED PERIPHERALS SETUP
Ampro Computers, Inc.
IDE HDD Block Mode : Enabled
IDE Primary Master PIO : Auto
IDE Primary Slave PIO : Auto
IDE Secondary Master PIO : Auto
IDE Secondary Slave PIO : Auto
IDE Primary Master UDMA : Auto
IDE Primary Slave UDMA : Auto
IDE Secondary Master UDMA : Auto
IDE Secondary Slave UDMA : Auto
On-Chip Primary PCI IDE : Enabled
ON-Chip Secondary PCI IDE : Enabled
USB Keyboard Support : Disabled
Init Display First : PCI Slot
Onboard Parallel Port : 378/IRQ7
Parallel Port Mode : ECP+EPP1.9
ECP Mode use DMA : 3
Onboard Serial Port 3 : 3E8H/IRQ4
Onboard Serial Port 4 : 2E8H/IRQ3
Interface Select Ser1 : RS232
Interface Select Ser2 : RS232
Interface Select Ser3 : RS232
Interface Select Ser4 : RS232
On-Board Sound Chip : Enabled
On-Board LAN Chip : Enabled
Assign IRQ for USB : Enabled
Onboard VGA Display : Enabled
VGA Flat Panel Type : 1
Onboard FDC Controller : Enabled
Onboard Serial Port 1 : 3F8/IRQ4
Onboard Serial Port 2 : 2F8/IRQ3
UART2 Mode : Standard
ESC:Quit
↑ ↓ → ←
: Select Item
F1 :Help PU/PD/+/-: Modify
F5 :Old Values (Shift)F2:Color
F6 :Load BIOS Defaults
F7 :Load Setup Defaults
Figure 2-13. Setup 7 — Integrated Peripherals Setup
! IDE HDD Block Mode —This items allows your hard drive system to use a mode where the
interface transfers large blocks of data instead of the normal small blocks, when enabled.
Enabled is the default state, and works for newer hard drives. Disable this feature if your drive
does not support block mode transfers.
! IDE Primary/Secondary Master/Slave PIO Mode — This item sets the PIO mode for devices
attached to the IDE interface. Auto (default) lets the BIOS automatically determine what mode
is the fastest for each device. Mode 1 through Mode 4 forces the BIOS to use the specified mode,
and overrides the MODE setting on the Standard CMOS Setup Screen, Setup 2.
! IDE Primary/Secondary Master/Slave UDMA — This item enables or disables support for Ultra
DMA/33 mode on the selected IDE device. When set to “AUTO”, Ultra DMA/33 will be used if it
is supported by the connected IDE drive.
! On-Chip Primary/Secondary PCI IDE — This items enables or disables the primary or
secondary IDE controller.
! USB Keyboard Support — This item is a legacy entry and must remain Disabled to use the ISA
memory region from D000:0 to D000:FFFF. This IRQ may be disabled for use elsewhere. This
does not prevent the USB keyboard from functioning.
! Onboard FDC Controller — This item enables or disables the on-board floppy disk controller.