Ameriphone DIALOGUE VCO - Manual (Page 12)

memory buttons shown in Figure 24.
Each button can be programmed (or
reprogrammed using the same proce-
dure) for a phone number up to 15
digits long.
To Program a Button, Follow these
Steps:
1. Lift the handset and press PROG
as shown in Figure 25.
2. Enter the phone number on the
keypad (Figure 26) just as you
would dial it normally.
Special Features
(Continued)
4. The VCO phone dials the emergency
number (if programmed) and transmits
this message: "HELP! I AM A VCO USER,
PLS RESPOND BY TYPING ON A TTY,
AND LISTEN TO ME ON UR PHONE,
(your name), (your address), (your
number) GA".
5. This message will re-transmit every
few seconds.
6. The message will stop when it starts
receiving the typed message from the dis-
patcher. Or, you can stop and start the
message by pressing .
7. Continue conversation by reading and
talking.
Memory dialing emergency service and
the emergency message feature are pro-
vided only as a convenience. Ameriphone
assumes no responsibility for customer
reliance upon these features.
Programming the Memory Buttons
You can automatically dial ten pro-
grammed telephone numbers using the
DIALOGUE VCO
M1
a. a. a. a. a.
POWER
RELAY REL MGS SPACE AUTO ANS
SIGNAL
M2 M3 M4 M5
SELECT MEMORY b
X
A
B
D
E
b. b. b. b. b.
Figure 24 - Memory Buttons
O
P
E
0 #
HOLD PROG
TONE
LO HI
FLASH REDIAL
VOL
AMPLIFY
*
Figure 25 - PROG Button
a. a. a. a.
M2 M3 M4
SELECT M
A
B
b. b. b. b.
Figure 23 - EMERGENCY Button
10