AMX DAS-AMP4 - Manual (Page 12)

Wiring and Connections
6 Carbon XA Amplifiers
Wiring Diagram - Expanded Configuration
FIG. 4 illustrates stacking up to three Carbon XA Amplifiers units per zone, to allow up to 12 speaker pairs
(24 channels) in a single zone:
To "stack" Carbon XA amplifiers, connect the To Keypad connector on the first Amplifier to the From
Controller connector on the second Amplifier. To add a third Amp to the configuration, connect the To
Keypad connector on the second Amp to the From Controller connector on the third Amp.
The Matrix Keypad can be connected serially between the Audio Controller and the first Amp as shown in
FIG. 4.
It can also be connected serially between the first and second Amp, between the second and third Amp, or to
the To Keypad port on Amp #3, but only one Keypad can be connected in one zone.
FIG. 4 Wiring Diagram - Expanded Configuration (showing three DAS-TAMP8-SIG 8-Channel Amps)
Note: Only one Keypad can be installed per zone
Mi-Series
Audio Controller
DAS-KP-LCD-G
Flush Mount LCD Keypad
Carbon XA
Amplifier #3
Carbon XA
Amplifier #2
Carbon XA
Amplifier #1