Konica Minolta bizhub PRESS C8000e - Manual (Page 52)

IC-601 5-12
5.2 Windows Vista/Server 2008/7 5
% In Windows Vista/Server 2008, click [Add a printer] on the toolbar.
The [Add Printer] Wizard appears.
4
Click [Add a network, wireless or Bluetooth printer].
Connected printers are detected.
% If no printer is detected, turn this machine off, then on again.
In this case, turn off the printer, and then wait approximately 10 seconds before turning it on again.
If you turn this machine on immediately after turning it off, it may not function correctly.
5
Select your machine from the list, and then click [Next].
% To use the LPR/Port9100 protocol, select the printer with its IP address.
% To use the SMB connection, select the printer with its "\\NetBIOS name\print service name". You
can check the NetBIOS name and print service name by selecting [Administrator Setting] - [Control-
ler] - [Controller NIC Setting Menu] - [SMB Setting] - [Print Setting]. In the default setting, the last six
characters of the NetBIOS name correspond to the low-order three bytes of the MAC address.
To check the MAC address, select [Configuration Page]. For details on how to output [Configuration
Page], refer to page 14-4.
% For the SMB connection, click [Next], and then click [OK] in the [Connect to Printer] page that ap-
pears.
% It may take some time to finish searching the entire list of printers.